How to make a LEGO Roller Coaster Part 3: Lift

Posted on Posted in Coaster1, Page-Instructions

This is part 3 of the How to make a LEGO Roller Coaster video’s. 8x 4459 Technic, Pin with Friction Ridges Lengthwise WITHOUT Center Slots
7x 6558 Technic, Pin 3L with Friction Ridges Lengthwise
6x 32062 Technic, Axle 2 Notched
6x 4519 Technic, Axle 3
2x 32278 Technic, Liftarm 1 x 15 Thick
3x 32015 Technic, Axle and Pin Connector Angled #5 – 112.5 degrees
6x 32192 Technic, Axle and Pin Connector Angled #4 – 135 degrees
6x 6536 Technic, Axle and Pin Connector Perpendicular
12x 62462 Technic, Pin Connector Round 2L with Slot (Pin Joiner Round)
4x 3794 Plate, Modified 1 x 2 with 1 Stud (Jumper)
4x 2817 Plate, Modified 2 x 2 with Pin Holes
4x 3710 Plate 1 x 4
2x 3020 Plate 2 x 4

4x 30586 Plate, Modified 2 x 8 with Door Rail
4x 3034 Plate 2 x 8
6x 4162 Tile 1 x 8
2x 3703 Technic, Brick 1 x 16 with Holes

2 thoughts on “How to make a LEGO Roller Coaster Part 3: Lift

Leave a Reply

Your email address will not be published. Required fields are marked *